View Single Post
  #2  
Old 03-06-2017, 04:46 PM
chevymaher's Avatar
chevymaher chevymaher is offline
Senior Member
 
Join Date: Mar 2014
Location: Kentucky
Posts: 1,477
Default

My powerglide it slides all the way to the tailshaft. I can check tomorrow if you like. It is a 68 model from my car. But it was in good shape when it came out.

Sounds like rust on the splines. One of my 4 speeds was wasted like that when I took it apart. Yoke only went on as far as it was when it was in the car and driveshaft installed. Take the tail shaft off and wire wheel with a drill and clean that puppy off. Or it may be rusted up in the yoke its self. In that case soak it with PB blaster and just keep sliding it on and off it will come loose.
Reply With Quote