View Single Post
  #2  
Old 02-11-2012, 02:51 PM
SS Shaun SS Shaun is offline
Senior Member
 
Join Date: Mar 2011
Location: poconos pa
Posts: 1,921
Send a message via AIM to SS Shaun
Default

and once i did that i used some tape to mark the bits so i knew how much i needed to drill


i didnt picture this but i drilled with a smaller bit first then a medium size bit then the 11/32 bit needed to tap the whole


once i got that done i tapped the whole with the 10x 1.5 tap


and then ended cleaned it with an air compressor and cleared out the and made sure nothing was left in there. here is what i ended up with


hope this will help everyone later on!
__________________
2005 dodge magnum daily driver
1988 mazda rx7 LS6 swap
1969 SS work in progress
Reply With Quote