Intake Manifold Question

[Pyasher]

Originally Posted by BillsCamino

What gasket have you been using and having issues with?

Edelbrock recommends the Edelbrock #7201 gasket...which is .060" thick. Same as a FelPro 1205.

Bill - I used a FelPro last time which was about 2 years ago.
I may try the Edelbrock one this time ( 3rd gasket)
Any specific reason why I should not machine the intake?
I just want it to run well - it has not been a major issue - sometimes it will idle a little rough and if I drive for a long time and get t hot when I stop for gas it will whistle for a minute or so on start-up.