Ray (shadowgray396) - repro dash

[Hank70SS]

Originally Posted by Bowtie-Bri

It should really make your dash pop. Hopefully it will fit as good as the original one.

Not quite! The glove box door fit is pretty bad. I'll see what I can do with it after the dash is in, too hard with the dash laying on a table. I don't have AC, I have the filler plate that goes above the heater controls. It's goes in from the back and fits tight against opening. This dash had a tab 1/2" x 3/4" at one corner of the opening. Had to cut that off smooth so the opening was flat all the way around. Then had to open the screw holes up in the plate to center in the opening. Had to open up the hole for the black circle that goes around the e-brake release, not a big thing. Wiper switch sits too low in the opening, not a big thing.

It'll look good, it's just taking a lot of time trying to get everything to fit the way it should.