|
|
|
#81
07-11-2015, 07:11 PM
|
|||
|
|||
Hrmm... I seem to remember some of those short pump pulleys having thin spacers behind them.
__________________
1972 SS 454 Chevelle LS5/M21/12 bolt 3.73 posi 1969 Malibu COPO L72/M20/12 bolt 3.31 posi 1968 Malibu LQ9/4L80E/12 bolt 3.73 posi 
|
|
#82
08-08-2015, 04:59 PM
|
|||
|
|||
|
Here you go John, seat is in and a/c is hooked up. Next up, get it in the garage and fix the ride height.
__________________
1972 SS 454 Chevelle LS5/M21/12 bolt 3.73 posi 1969 Malibu COPO L72/M20/12 bolt 3.31 posi 1968 Malibu LQ9/4L80E/12 bolt 3.73 posi
|
|
#86
09-02-2015, 09:48 PM
|
||||
|
||||
|
Looking good
__________________
Ray 1970 SS Chevelle Van Nuys Built
|
|
#87
09-03-2015, 01:15 AM
|
||||
|
||||
|
That is going to look really good on there.
|
|
#88
09-05-2015, 11:13 AM
|
|||
|
|||
|
The only thing wrong with the current wheels is that they are reversed to the inside too much. (4.5" back space) I was trying desperately to get wheels with a 2" - 2.5" back space. But, those are made of unobtainium. These have a 3.5 back space, it should help a decent amount. Going to run small, 3/16" spacers on the rear to even things out better.
I still have to pull the rear out to flip the perches to the top of the axle tubes. That will fix the ride height.
__________________
1972 SS 454 Chevelle LS5/M21/12 bolt 3.73 posi 1969 Malibu COPO L72/M20/12 bolt 3.31 posi 1968 Malibu LQ9/4L80E/12 bolt 3.73 posi
|
 |
|
|
Linear Mode
