#951
|
|||
|
|||
LOL i am sure it would of
__________________
2005 dodge magnum daily driver 1988 mazda rx7 LS6 swap 1969 SS work in progress |
#952
|
||||
|
||||
Quote:
The Alt. pulley is nearly new, as are the rest of the pulleys. Actually put on a much larger alternator pulley with a deeper groove to try and slow the belt down a little but it is still flying off. I think I have a solution to the problem on the way though. What I don't understand about the miss at 5k is that after about .5 seconds the car picks up and pulls all the way to 6200 or so where it shifts. I did replace the module with another I had sitting around and will swap out the coil with a D.U.I. 50k coil later this week just to eliminate those from the equation. I found a few threads with similar issues related to the MSD Pro-Billet HEI distributors and it was often suggested that the modules are not the best. I'll see.... Hopefully nothing too difficult to pin-point.
__________________
Eric 496 cu. in. "cruiser" Assembled & tuned by Mo's Speed Shop - Dallas, GA |
#953
|
||||
|
||||
Well, if the miss comes and goes, it's not the valve springs. I think you have it on the run with the module. Keep us posted in case I come across something like that.
__________________
Alan 1964 Chevelle SS Speed's expensive, how fast do you want to go? |
#954
|
||||
|
||||
Took the chevelle out today for a couple of outings. Car has only 15 miles on it so far.
__________________
Ray 1970 SS Chevelle Van Nuys Built Last edited by shadowgray396; 02-01-2014 at 01:37 PM. |
#955
|
|||
|
|||
put a spacer between the carb (Edelbrock) and intake due to it flooding sfter start up and smoking .Its been like this ever since we put the new motor in..
|
#956
|
||||
|
||||
Put in a new Cowl induction flap door and new vent knobs and ordered a heater core that someone took out.
|
#957
|
||||
|
||||
Man, that's a beautiful car.
__________________
Alan 1964 Chevelle SS Speed's expensive, how fast do you want to go? |
#958
|
||||
|
||||
Drove to Hell and back, Hell, Michigan that is. Yesterday was a beautiful day for a ride. 77 degrees, leaves are starting to change, perfect day for a ride.
|
#959
|
||||
|
||||
Thank you, still working a few bugs out of it but almost there. Goes to the alignment shop next week and should be ready for a nice long drive.
__________________
Ray 1970 SS Chevelle Van Nuys Built |
#960
|
|||
|
|||
well its been a LONG time since i had time to work on my chevelle. But i finally got the t56 under the car and INSTALLEd very little cutting. about as much as putting in a tko
__________________
2005 dodge magnum daily driver 1988 mazda rx7 LS6 swap 1969 SS work in progress |
|
|