ChevelleForum.net

Go Back   Chevrolet Chevelle Forums > Chevrolet Chevelle Garage > Chevelle Maintenance

Reply
 
Thread Tools Display Modes
  #1  
Old 06-08-2013, 02:43 PM
Scoob Scoob is offline
Junior Member
 
Join Date: Jun 2013
Posts: 2
Default Broken door latch assembly

Any ideas on how to open the door when a spring inside the door latch assembly has broken? All of the linkage is intact, but the door latch won't spring open. To remove the door latch assembly normally, the door must be open. My only thought is to take a dremel to the latch assembly and cut it apart from inside the door.
Reply With Quote
  #2  
Old 06-09-2013, 07:42 AM
shadowgray396's Avatar
shadowgray396 shadowgray396 is offline
Senior Member
 
Join Date: Dec 2009
Location: Oregon City, Oregon
Posts: 6,062
Default

Starting at the top:

There are four coil springs in the mechanism, one as described above to hold the push button lever against the push button push rod.

There is one "over center" coil spring that holds the door lock rocker lever either in lock position or in unlock position.

There is a coil spring on the latch plate "ratchet" plate that pulls the ratchet plate toward the latch plate.

There is one on the latch plate that pulls the latch plate to the open position. The latch plate is the part of the mechanism that locks onto the striker pin in the door jam.

Pulling on the inside door handle or pushing on the outside push button works through levers to pull the ratchet plate away from the latch plate, allowing the latch plate spring to pull it back, unlatching the door.

There is a "half latched" notch on the latch plate. This would allow the door to be partially latched but not open all the way. Even on "half latched" position, actuating the release mechanism should open the door.

There is a plastic "bumper" at the bottom with a spring to push it toward the outside of the door against a metal stop.

If the striker pin is adjusted too low, the head could drop below the metal stop making the door hard to open.

A broken spring in one of the upper locations could drop pieces into the latch and ratchet mechanism but I don't see how it could prevent "full open" if it releases at all.

In the picture taken of the edge you can see part of three of the springs, the push button lever spring, the door lock rocker spring, and the ratchet plate spring. The other two are not visible in that picture.

Try pushing hard from the inside, use both feet and hit it hard from inside may work also.



__________________
Ray
1970 SS Chevelle Van Nuys Built

Last edited by shadowgray396; 06-09-2013 at 08:03 AM.
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 05:34 AM.



Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Audiokarma.org