ChevelleForum.net

Go Back   Chevrolet Chevelle Forums > Chevrolet Chevelle Garage > Chevelle Engine & Trans

Reply
 
Thread Tools Display Modes
  #11  
Old 10-30-2018, 09:46 PM
kevinw kevinw is offline
Senior Member
 
Join Date: Sep 2017
Posts: 128
Default

question. my 350 threw a rod end of sept, low oil.currently machine shop is workingthe block and heads, bored 30 over.
I plan to basically use the stock parts to have it rebuilt, I had a edelbrock alum intake, 600 cfm 4 brrl, and headers. is there anything before they start putting new parts on I should consider doing? I assume the engine will retain the same h.p. as before? trying to keep total cost around $3000 which is what I was quoted for total rebuild and re install engine in car. thanks.
Reply With Quote
  #12  
Old 10-31-2018, 08:54 PM
flash flash is offline
Senior Member
 
Join Date: Dec 2009
Location: Canton Georgia
Posts: 8,292
Default

Im considering a rebuild on my wife's original motor for my Vert ,was hers , only had 55,000 miles on it but it drank oil badly . Im thinking about using a roller cam ,Aluminum heads and fuel injection . Your plan sounds pretty good though .
__________________

John
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 10:20 AM.



Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.
Audiokarma.org