rear seat frame question

[SS Shaun]

Ok so i went to put in my seat frames so i can make my frame mounts fit in the right spot. So i went to bolt in the rear upper part and the mounting holes are no where near the big U looking part that bolts into the rear. and then the lower part doesnt seem to fit correctly at all. So i ask does anyone know what seat frames these are?




Maybe this might help



anyone have any ideas?

[flash]

Looks like a Pontiac ,Buick ,or Olds pattern but still should fit if its A body .I think I remember reading that 4 door and convertible are different though.

[SS Shaun]

I will put them in the car and snap a picture of them. They are really wide. unless my rear is tubbed and i dont know about it

[SS Shaun]

also another thing how can i cross reference those numbers to see what they are?

[SS Shaun]

here are the front seats

[Hank70SS]

Those are not 69 Chevelle seats. Convertible are definitely different than coup, not sure about 4 door but could see where they might be. Plug in GM followed by the number into Google and see what you get.

[SS Shaun]

i tried doing that. I tried
GM
GM part #
GM part number
and nothing

[SS Shaun]

btw i measured it and it measures at 54.5 inches that is way to big isnt it?

[shadowgray396]

Should be for Chevelle's

68-69 rear seats are 58",
70-72 coupes are 54.5", 70 to 72 use a filler panel in the back that the ash tray sits in.
68-72 convertibles are 52".

This looks like your seats in a classified add I found. Listed also for 442 and GTO. Old add it may be your seats.

[SS Shaun]

well i figured out where the seats are from. the back ones anyway


angering..lol