#11
|
|||
|
|||
Ken its an Comp Cam push rod i got from summit i have the part number let me look it up and i will post it. I dont want to cut the pump because it still covered under warranty i think
__________________
2005 dodge magnum daily driver 1988 mazda rx7 LS6 swap 1969 SS work in progress |
#12
|
|||
|
|||
Stock pump pushrod is 5 3/4" long and 1/2" diameter...BBC & SBC are the same.
__________________
2017 Camaro RS -217 cu in 365 HP w/8 speed auto 1967 Camaro SS -5.3L LS w/4L60E & 4.11 12 bolt 2019 Cadillac XT5 3.6L V6 w/310 HP & 8 speed AWD |
#13
|
|||
|
|||
here is the push rod i am using in my motor now
http://www.summitracing.com/parts/cca-4607
__________________
2005 dodge magnum daily driver 1988 mazda rx7 LS6 swap 1969 SS work in progress |
#14
|
||||
|
||||
Well, that's the correct size Shaun. I guess its time to go electric.
__________________
Today, is the tomorrow you worried about yesterday..enjoy it !!! |
#15
|
|||
|
|||
I'd pull the fuel pump and take a good loon look at it's pump lever.
Any indications of the pushrod skipping off the pump lever...either on the end or off to the side. Like I mentioned previously...earlier this summer, I got FOUR bad pumps in a row from O'Reilly. The levers were too short allowing the pushrod to fall off the lever's end. |
#16
|
|||
|
|||
well i think i am going to have to put the blame on the push rod. I can't get it out for some reason! I pulled the fuel pump out, opened the screwed in bolt on the bottom of the block and turned the key once just to see if it would move and it moved but only seemed to be about a half inch to 3/4 of an inch. I can push the rod up and spin it freely. I got a needle nose and tried to pull on it and nothing. i put as much force on it as i could, but nothing! now what? i can't leave that push rod in place and go electric can i? I have to remove that rod correct?
__________________
2005 dodge magnum daily driver 1988 mazda rx7 LS6 swap 1969 SS work in progress |
#17
|
|||
|
|||
At the front of the block there is a 3/8 bolt hole that intersects
the pushrod hole....Make sure the bolt that is supposed to seal this hole is not to long and rubing on the pump rod. |
#18
|
|||
|
|||
not sure what you mean its a big block i thought only the small block had that
__________________
2005 dodge magnum daily driver 1988 mazda rx7 LS6 swap 1969 SS work in progress |
#19
|
|||
|
|||
this is what you are talking about
__________________
2005 dodge magnum daily driver 1988 mazda rx7 LS6 swap 1969 SS work in progress |
#20
|
||||
|
||||
That is it.
|
Thread Tools | |
Display Modes | |
|
|