#1
|
|||
|
|||
painless wiring help please !
Hello gang !
So I'm in the process of wiring my 1965 chevelle ss. its a 327 , with a th350 trans. floor shifter, no tilt, ac removed. Im haveing issues since I started this project as my fine who was suppose to do the job backed out.its a painless wiring universal kit ( dont ask why ) My first question is.. I ordered a signal switch from dons east coast restoration,,, its a 7 wire connector, but the orignal other end (female) is a 8 wire connector ??? My wiper switch is a 3 pin connector , and my wiper motor is a 2 pin connector ( without the washer pump I pretty sure ) how would I connect this ? my driver's side dash has a small 1/2 hole ?? anyone know whats it for ??? thanks for any help! |
#2
|
|||
|
|||
i forgot to mention ... how do i turn on the hazards ?? is there a seperate switch ???
|
#3
|
||||
|
||||
Not sure why they call them painless. Sorry can't help much. Not sure about the hazards on a 65, mine is on the steering column, below the ignition switch. I believe your ignition switch is in the dash isn't it?
|
Thread Tools | |
Display Modes | |
|
|