ChevelleForum.net

Go Back   Chevrolet Chevelle Forums > Chevrolet Chevelle Garage > Paint and Body

Reply
 
Thread Tools Display Modes
  #1  
Old 03-17-2017, 05:21 PM
size-o size-o is offline
Member
 
Join Date: Jun 2016
Location: Sherwood Park, AB, Canada
Posts: 47
Default Panel Replacement Order

Since I bought my 68 Chevelle, I have been stressing out. I bought the car from someone that was not able to finish it. The trunk pan has been removed, the lower half of one rear quarter has been cut and both wheel tubs still need to be removed and replaced. The previous owner did all the right things and drilled out all the spot welds.

What should be the order of replacement, or should I put all the panels in place using a boat load of vice grips and tack them into place? Or.... and this is where I'm appealing to all of you. Hopefully from the photo you can see what I'm referring to.

Thanks for your help!!!

Perry
Attached Images
File Type: bmp IMG_0118.BMP (379.7 KB, 90 views)
Reply With Quote
  #2  
Old 03-20-2017, 02:23 PM
shadowgray396's Avatar
shadowgray396 shadowgray396 is offline
Senior Member
 
Join Date: Dec 2009
Location: Tigard, Oregon
Posts: 5,984
Default

Couldn't open the photo. But put all your panels and trunk pan in place to test for fit. They always need some adjusting first to make sure everything lines up. Hard to adjust once welded into place. The other thing to check is make sure your body mounts are good before you start to line things up. If they are shot then everything is going to be off.
__________________
Ray
1970 SS Chevelle Van Nuys Built

Last edited by shadowgray396; 03-20-2017 at 02:26 PM.
Reply With Quote
  #3  
Old 04-27-2018, 02:49 AM
dconnor dconnor is offline
Member
 
Join Date: Feb 2017
Posts: 33
Default

This will give ideas/tips on installing the panels -- hotrodders.com/forum/69-chevelle-quarter-panel-replacement-446954.html
Reply With Quote
  #4  
Old 04-27-2018, 10:00 AM
mestorod70 mestorod70 is offline
Senior Member
 
Join Date: Jun 2013
Location: honah lee in a cave by the sea
Posts: 390
Default

Plus one on new body mounts before fitting metal.
Urethane mounts are better.
Along with clamps you may use self drilling sheet metal screws.
Some panels are easier to prime before final welding...epoxy primer.
Dont forget weld thru primer before welding.
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 04:43 AM.



Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.
Audiokarma.org