#1911
|
|||
|
|||
Strange...my FedEx box was delivered at 9:45pm last night. Noticed it at the side door when I let the dog out this morning.
I had checked the tracking number late yesterday around dinner time...showed delayed due to "weather".
__________________
2017 Camaro RS -217 cu in 365 HP w/8 speed auto 1967 Camaro SS -5.3L LS w/4L60E & 4.11 12 bolt 2019 Cadillac XT5 3.6L V6 w/310 HP & 8 speed AWD |
#1912
|
|||
|
|||
Since the shooting all their tracking is messed up ,the bodyshop said their usual deliveries are much later than usual . You got the wagon ready to go yet ?
__________________
John |
#1913
|
|||
|
|||
Well...yes and no...
Wagon ran for twenty minutes today...until a BRAND NEW fuel pump decided to cease doing it's intended thing. Ran just long enough to warm up, top off fluids, set timing, and adjust carb. Going out now to pick a replacement one up...of course, not in stock earlier today so had to wait for the afternoon parts delivery from the warehouse. Strange that no one around here (AZ, O'Reilly, Advance) stocks a big block OEM type fuel pump. Consequently, missed my afternoon Muffler Shop appointment. So...no Chevelle Show WITH Chevelle for me although we'll be there. Be sure to look me up John...$$
__________________
2017 Camaro RS -217 cu in 365 HP w/8 speed auto 1967 Camaro SS -5.3L LS w/4L60E & 4.11 12 bolt 2019 Cadillac XT5 3.6L V6 w/310 HP & 8 speed AWD |
#1914
|
|||
|
|||
Bill ,sorry to hear the wagon wont be there ,was looking forward to seeing the upgrades .
__________________
John |
#1915
|
|||
|
|||
Ray, I found this image online of a 72' W-code car without AC. The orange wire looks like the one in my engine bay - it appears to run to the heater box. (for the fan motor, I think?) Anyhow, I don't believe I need it, my car has AC. Not sure why they put that in my harness? It's an American Autowire harness IIRC. Now I am just down to the one black wire I can't figure out.
__________________
1972 SS 454 Chevelle LS5/M21/12 bolt 3.73 posi 1969 Malibu COPO L72/M20/12 bolt 3.31 posi 1968 Malibu LQ9/4L80E/12 bolt 3.73 posi Last edited by carpoor; 05-02-2014 at 07:10 PM. |
#1916
|
||||
|
||||
You are correct.
__________________
Ray 1970 SS Chevelle Van Nuys Built Last edited by shadowgray396; 05-03-2014 at 08:41 PM. |
#1917
|
||||
|
||||
Put the intake manifold back on. Distributor and valve covers are on. Have to put on cap and wires, hook up alt and fill the rad.
May have found why I've had a problem getting the gaskets to seal. There is a metal tray that sits over the lifter valley. Three tabs on each side clip over bottom edge of head and stick up enough that 2 of the 3 are sandwiched between head and intake. Maybe keeping the intake from pulling down tight against gaskets. Trimmed them off so we'll see. |
#1918
|
|||
|
|||
I guess my harness is a multi fit? Because it also had the wiring to my AC box. Maybe when I redo this car in another 10-15 years, I will pull out the harness and remove the wires I do not need.
__________________
1972 SS 454 Chevelle LS5/M21/12 bolt 3.73 posi 1969 Malibu COPO L72/M20/12 bolt 3.31 posi 1968 Malibu LQ9/4L80E/12 bolt 3.73 posi |
#1919
|
||||
|
||||
flash did your UPS have a shooting ?
__________________
Get in, sit down, shut up, hold on...cause Ms Grumpy is driving ! For the audio geek try: www.audiokarma.org |
#1920
|
||||
|
||||
Went to Cruise today and had this picture made for the garage.
__________________
Ray 1970 SS Chevelle Van Nuys Built Last edited by shadowgray396; 02-28-2015 at 08:11 AM. |
Thread Tools | |
Display Modes | |
|
|