ChevelleForum.net

Go Back   Chevrolet Chevelle Forums > Chevrolet Chevelle Garage > Chevelle Suspension & Chassis

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #1  
Old 03-20-2016, 07:32 PM
paulywood paulywood is offline
Senior Member
 
Join Date: Sep 2014
Location: Mid-Michigan
Posts: 127
Default Tall ball joints+drop spindles=problem?

I put the 2" drop spindles on my car to lower the front end. After reading about the advantages of the tall ball joints I decided to also install those while I was doing the front end. But now I think I might have issues. The first is if there will be enough adjustment with the stock control arms. The tires are toed way in. The 2nd is that I had to crank the tie rod ends all the way in just to get them installed and I think they still need to go in more. I think I might pull them back off and cut an inch off the end of each one to make sure there is enough adjustment when I get it aligned. But if I need to replace the control arms (upper, lower or both?) I would like to do it all at once. Any opinions? I can get a picture if it helps.
__________________
1972 Chevelle Malibu Convertible Project
Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 05:45 PM.



Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Audiokarma.org