ChevelleForum.net

Go Back   Chevrolet Chevelle Forums > Chevrolet Chevelle Performance > Chevelle Pro-Touring

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #1  
Old 02-11-2012, 02:50 PM
SS Shaun SS Shaun is offline
Senior Member
 
Join Date: Mar 2011
Location: poconos pa
Posts: 1,921
Send a message via AIM to SS Shaun
Default how to convert your LQx LMx to use an LS1 Alternator bracket

ok guys i got my LQ9 and i wanted to use an LS1 intake and all that stuff but then i got my bracket and i noticed the whole wasn't there for the alternator.

(barrowed this picture from another site.)
So i said well the spot is there why not make the whole. I was scared to death to do it but if i wanted to use the ls1 intake and all that good stuff so here are the tools you will need
a drill
i used 3 bits one small for the pilot hole one a little bit bigger and then an 11/32 bit
a 10x1.50 plug tap


So what i did was bolted the bracket on with the bottom bolt
and lined it up



I took a very pointy pencil and lined it up in the center


once i marked it i measured how much i needed to drill
__________________
2005 dodge magnum daily driver
1988 mazda rx7 LS6 swap
1969 SS work in progress

Last edited by Ms Grumpy; 02-12-2012 at 10:03 AM. Reason: member request
Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 05:38 AM.



Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Audiokarma.org