#1
|
|||
|
|||
Suspension Opinion
While rebuilding the front brakes on my 72 I also wanted to lower the front end. I'm not a big fan of how it sits higher in the front than the rear so I ordered spindles with a 2" drop. Since I was pulling the spindles anyway I figured I would replace the tie rod ends and ball joints. After reading the sticky about tall ball joints I figured I would go that route. Any issues on using the drop spindles and tall ball joints?
|
#2
|
||||
|
||||
I'm can't see it being a problem unless the spindles you ordered have the tall upper ball joint mount too. I kept the same height ball joint but my spindles have the taller upper mount.
__________________
Justin Projects: 70 Chevelle Malibu http://s132.photobucket.com/user/qua.../70%20Chevelle |
#3
|
|||
|
|||
I finally go the last parts for the front end. I'll get everything installed tomorrow (hopefully) and then I can see how it sits.
__________________
1972 Chevelle Malibu Convertible Project |
Thread Tools | |
Display Modes | |
|
|