#11
|
|||
|
|||
Dave:
Bumping this one up. What is going on with the engine and driving? Durand |
#12
|
||||
|
||||
Just got news theres more metal shavings in the oil then I would like.
Not jumping to conclusions but if there is more damage, then I am considering stroking this motor. I am going to show how little I know about motors with my next question. I know the entire rotating assembly would have to be changed but could I reuse any of the old parts. Heads ? Thanks Dave
__________________
Dave |
#13
|
||||
|
||||
yes! heads pushrods intake rockers what is changed is the crank, rods, pistons,balancer % flywheel everything else is the same
|
#14
|
||||
|
||||
Sounds expensive.
__________________
Dave |
#15
|
||||
|
||||
You can buy stroker kits, with everything in them. I kind of lean towards using GM parts, but Eagle ans Scat both make kits.
|
#16
|
||||
|
||||
You can buy stroker kits, with everything in them. I kind of lean towards using GM parts, but Eagle ans Scat both make kits.
You'll definitely be able to use your top end the way it is...carb, intake, valvetrain, distributor. |
#17
|
|||
|
|||
Plenty of room under the hood of the 72, good luck!
|
#18
|
|||
|
|||
Ha Ha, pulling this thread out of the weeds !! I saw this car today sitting in the garage....Nice looking ride Grumpy Anyway, did you end up stroking the motor ?? It's not unusual too see alot of metal "slivers" or "shavings" after a fresh rebuild in the oil. Now if they are larger "chunks" and you see perhaps some copper mixed in there, then I'd be worrying . Nice car though man !!!
GD |
#19
|
||||
|
||||
Thanks GD. Just one correction to your post. The car is actually mine.
Here is a link to what we actually did with the motor. http://chevelleforum.org/showthread.php?t=1101
__________________
Get in, sit down, shut up, hold on...cause Ms Grumpy is driving ! For the audio geek try: www.audiokarma.org |
#20
|
|||
|
|||
Get him Ms Grumpy ,Joan lets folks know the vert is HERS too.
__________________
John |
Tags |
350, engine |
|
|