#3081
|
|||
|
|||
You do nice work Brian. You are always busy.
|
#3082
|
|||
|
|||
Thank you Tony, I try.
__________________
1972 SS 454 Chevelle LS5/M21/12 bolt 3.73 posi 1969 Malibu COPO L72/M20/12 bolt 3.31 posi 1968 Malibu LQ9/4L80E/12 bolt 3.73 posi |
#3083
|
|||
|
|||
Cleaned the interior, and ordered a magnaflow muffler at 4wheelonline to quiet down my exhaust.
|
#3084
|
|||
|
|||
Get the longest case you can fit. I went with 18" case mufflers on my 72. Factory shows 19.5" is what they had stock. I have a 22" case Magnaflow on my truck with two Dynomax race bullets in front of it. Killed the rasp and 99% of the drone. LS engines are known for both - rasp and drone.
__________________
1972 SS 454 Chevelle LS5/M21/12 bolt 3.73 posi 1969 Malibu COPO L72/M20/12 bolt 3.31 posi 1968 Malibu LQ9/4L80E/12 bolt 3.73 posi |
#3085
|
|||
|
|||
Been pecking at it here and there. On the home stretch though. Passenger door is off, bodywork started. Rehung drivers door. And sanding the passenger door jamb.
The toolbag that butchered the bodywork on my car even smeared bondo in the door jambs... WHY?! Took a break from it today and picked up a Craigslist score, a set of factory 69-72 disc brake spindles/steering arms/backing plates. Going to need them for my 69.
__________________
1972 SS 454 Chevelle LS5/M21/12 bolt 3.73 posi 1969 Malibu COPO L72/M20/12 bolt 3.31 posi 1968 Malibu LQ9/4L80E/12 bolt 3.73 posi |
#3086
|
||||
|
||||
Looking good there.
|
#3087
|
|||
|
|||
Put in a few hours today, trying to get everything ready for primer. Fixed a few small holes under the hinge... same as the drivers door, not nearly as bad.
__________________
1972 SS 454 Chevelle LS5/M21/12 bolt 3.73 posi 1969 Malibu COPO L72/M20/12 bolt 3.31 posi 1968 Malibu LQ9/4L80E/12 bolt 3.73 posi |
#3088
|
|||
|
|||
Finished the hand sanding, and got some 2K primer on everything. Not pictured are the 2 front fenders and the pan under the rear bumper. I keep finding small blemishes in the front fenders. I'm sure that I am driving my father nuts, but I am after perfection... or as close as possible. I have come too far to half ass it at this point.
__________________
1972 SS 454 Chevelle LS5/M21/12 bolt 3.73 posi 1969 Malibu COPO L72/M20/12 bolt 3.31 posi 1968 Malibu LQ9/4L80E/12 bolt 3.73 posi Last edited by carpoor; 04-09-2019 at 02:27 PM. |
#3089
|
|||
|
|||
Getting closer to paint! When do you think you will spray it?
|
#3090
|
|||
|
|||
Hoping sooner than later, but not 100% sure when. I would say no later than the 1st week of May though.
Waiting for it to warm up, then heading over there to see what I can get done.
__________________
1972 SS 454 Chevelle LS5/M21/12 bolt 3.73 posi 1969 Malibu COPO L72/M20/12 bolt 3.31 posi 1968 Malibu LQ9/4L80E/12 bolt 3.73 posi |
Thread Tools | |
Display Modes | |
|
|