#1431
|
||||
|
||||
Looking good. Won't be long now
__________________
Ray 1970 SS Chevelle Van Nuys Built |
#1432
|
|||
|
|||
next is to figure out my brake issue still. once that is done i am going to put my interior together and got to find a new column and should be going down the road
__________________
2005 dodge magnum daily driver 1988 mazda rx7 LS6 swap 1969 SS work in progress |
#1433
|
|||
|
|||
Got the front suspension and complete disc brake rebuild project completed this afternoon on the wagon.
Along with new fan belts, hoses, and valve cover gaskets...I'm now ready for the trip to the Ohio show next week. That is...I will be after a front end alignment appointment on Monday...
__________________
2017 Camaro RS -217 cu in 365 HP w/8 speed auto 1967 Camaro SS -5.3L LS w/4L60E & 4.11 12 bolt 2019 Cadillac XT5 3.6L V6 w/310 HP & 8 speed AWD |
#1434
|
||||
|
||||
Got a front end alignment and a nightmare oil change. I am so glad the day is over. Tomorrow I will start with a tire balancing at 8am. Just hoping tomorrow goes better than today.
__________________
Get in, sit down, shut up, hold on...cause Ms Grumpy is driving ! For the audio geek try: www.audiokarma.org |
#1435
|
||||
|
||||
Need to clean the car up for a car show again on Saturday. Helping my brother inlaw with his show.
__________________
Ray 1970 SS Chevelle Van Nuys Built |
#1436
|
||||
|
||||
Drove the "hulk" to work today! Hopefully it'll be an uneventful trip!
__________________
Eric 496 cu. in. "cruiser" Assembled & tuned by Mo's Speed Shop - Dallas, GA |
#1437
|
||||
|
||||
Get to clean off the hamburger grease off my car tonight from the barbeque smoke today at the car show. I was parked at least 100 ft from it today, but still got on the car.
__________________
Ray 1970 SS Chevelle Van Nuys Built |
#1438
|
||||
|
||||
Dropped off at the upholstery shop for new headliner, package tray, carpet and getting the console done. Hope to have it back next week.
|
#1439
|
|||
|
|||
With only one "good" arm, I went out and accomplished this:
Not an exact, perfect restoration. (most concourse restorations have Quanta polish their drive shaft, then apply the stripes in a lathe) But, I drive all of my junk. So, used a wannabe "bare steel" paint, satin clear, and then used some basic enamel paints for the stripes today. I had the main drive shaft done about a month ago, just hadn't had time to get down to the paint store to get three pints of what I needed for the stripes. Truly wanted to do more, but I am just unable to do much right now.
__________________
1972 SS 454 Chevelle LS5/M21/12 bolt 3.73 posi 1969 Malibu COPO L72/M20/12 bolt 3.31 posi 1968 Malibu LQ9/4L80E/12 bolt 3.73 posi |
#1440
|
||||
|
||||
Not to bad for the one armed man. lol
__________________
Get in, sit down, shut up, hold on...cause Ms Grumpy is driving ! For the audio geek try: www.audiokarma.org |
Thread Tools | |
Display Modes | |
|
|