I finished fitting the drivers outer wheelhouse piece and welded it in. I also reshaped the drivers trunk drop off, fitted it, and welded it in. I also split the face of the outer rocker replacement and welded it back so that the face of it was the same as stock. The rocker I got was .080 more narrow across the face of it.
Attachment 2681

Attachment 2682

Attachment 2683

Attachment 2684

Attachment 2685

Dropped a pair of Sportsman II SBC heads off at my machinist's shop for freshening up and installing a new set of Comp hyd roller springs, retainers, and locks.
Working on building another 383 stroker roller small block engine.

For what, I don't know yet... :cool:

Sounds great!A stroker for a stroker!

started to put on my exhaust lastnight only got one side done..lol
http://i114.photobucket.com/albums/n...psdb096408.jpg

Looking Good

Made plans to have new springs put on the front. When they were installed last year we only cut 1/2 a coil off, but they settled A LOT. Bummer. So we start all over, I told grumpy that we are not going to cut them at all, he said that it will probably look funny. So as soon as I have them in I will take a pic and we will see what you guys think.

I went out to the shop to check on the cars today during the downpour but did nothing ,damn Im sick of RAIN.

Thought about it, especially while sitting in traffic driving my van. flash...I hope your weather clears soon.

If I still owned a Chevelle Ibwould most Definately clean its clock

finally got the motor in the car

http://i1116.photobucket.com/albums/...ps8a887621.jpg