How about a nice set of fenders?

Pat

Stock front sway bar from a 70 Malibu, 15/16", not the 1.25" bar.
Chrome 4 bolt rad top plate.
Unboxed lower control arms.
Some 70 headlight bezels.
Chrome top alt bracket form a 70 BBC.
70 307 emblems.

Everything is just driver quality but if you can use it it's yours.

On the top of my head I can think of.

1. Leaking heater core
2. 3 broken spark plugs
3. 1 cut spark plug wire
4. 1 broken body mount (just did that today)
5. A couple pounds of sandblasing sand that was under my carpet when I pulled it out.
6. A cheap yellow corvette model that I won at a car show..yeah Hank you were there at Bakers and was really jelous when I won it.
7. Assorted bolts (SAE and Metric) that held my inter fender wells in, I knew I was in trouble when I had to keep going from 3/8 to 10MM wrench to remove them. ( I went and bought the new kit from NPD)

I really need to clean up this mess.

Seriously, I have some stuff that I know others can use, I just have to go in attic and see what it is...

I have changed the engine harness and the front end harnes so if anyone needs any connector from them I do have them and they are yours if you need them.

Ric, do you have the plastic piece that goes on the end of the water temp lead? My sender has the post and the connector slips on from the side. I need the plastic cover that has an opening along the side where it slips on the sender.

Hank, I should have and will pull the harness down from the attic and see what I got.

Hank, is the green wire...I have one on my new harness but there is not one on my old harness that I can find..which is really wierd.

Yup, the green wire. Thanks for looking Ric.