Been too busy with trucks today ,besides Chevelle is not here .

Ate some more dust today, too hot. I'm done for today, four hours is enough. Borrowed a friend's stud gun/dent puller and fixed two small dents. In the process of removing more primer and filler - I found several more areas that need attention. :(

I hear ya 4 hours is enough. I doing basically the same thing on the boat inside now. After 4 hours I am ready to clean everything up and call it till the next time.

Looking good your getting with it tho.

Cleaned the intake manifold and replaced the valve cover.

I had good intentions today, but was hampered by equipment failure after only a few hours. My pad that the stripping discs stick to came apart. Oh well... there's always Friday. (My next day off)

I found more filler where it wasn't needed around the rear window. The guy obviously didn't understand that certain areas of these cars are round and concaved from the factory.

Car has just been sitting in the garage these days. Not been able to get it out much. Might be time to think about selling it, and let someone else enjoy it.

Been there Ray...no more Chevelles here. Enjoying the comforts of a new Camaro though. ;)

She's pretty much naked now, every place the grinder will fit is down to bare metal. Already started to fill and block the deck lid and passenger side quarter panel.

Looking good keep your nose to the grindstone.

I looked at the Malivert through the bodyshop fence for a brief minute .