Need a picture
 

Ran into a snag with the uphostery guy today. He ruin one of my seat backs trying to make the head rest fit correctly on the seat. I need a picture of the front part of the back of the seat with the head rest installed showing how close it should fit. He was trying to fill in a gap that I think should be there from the factory. This picture I have does not show it well enough. Had to order a new seat back today. Here we go again.

http://i777.photobucket.com/albums/y...nterior-Lt.jpg

Ray

Ray,I have a good interior shot in my photobucket. Hope this helps.

Thanks Gary, I need a good side view with the head rest all the way down and how the top of the back looks with the padding against the head rest. Trying to find out if we need to bend out the upper springs to make the seat look correct (Profile of the front of the back seat).

Ray.

Not sure if these help

http://www.chevelleforum.net/album.p...&pictureid=800

http://www.chevelleforum.net/album.p...&pictureid=561

If not I'll look through some more of my unposted photo.

Dave

Dave, it does help, for some reason my head rest are sticking way out in front of the top of the seat.

Thanks Ray

I could use a picture of the screws that were used on the lower quarter interior panel by the back seat. The ash tray is in that panel on top.

Be glad to get you some but the cars tucked away till this snow/sleet crud passes by. May not be until early next week. Sorry.

Dave

Dave, that will work. Thanks