[westender]

Finally got back into getting the short block done...wrapped the whole motor in plastic front to back and end to end....just cut a small hole where the bolt needed to be removed.....taped that area off..several times.....then i was comfortable to go ahead and drill out the bolt to get a easy out into it... i used my telescopic magnet to keep getting the shavings out during drilling....didnt have to drill much which was nice....ended up using this cheap little gasmo called "Grab Bitz" which you just put in your drill and put drill in reverse....worked great...walked the broken bolt piece right out....flushed the area with wd-40 to get out any last bit of shavings.....then carefully cut the plastic and pulled it off the motor....so..now I am back to getting motor done and get it into that car....