A good day of progress today. I got my new heater core and blower motor in. Then I got the coils cut down.
I took a coil and a half out of each one which dropped the front end about 3". That sounds like a lot, but keep in mind it was pinned against the bump stops before, so now it's about normal to an inch lower than stock. It sits nice, but I have to get some more alignment shims. My camber went a little positive after I lowered it. It's still better than the 3 degrees of negative camber I had before.
I hope to get the rear suspension done tomorrow, but it looks like it's gonna be a busy day in the shop. As soon as the rear suspension is in, I can start to wire the car. ....getting closer.
