Put the intake manifold back on. Distributor and valve covers are on. Have to put on cap and wires, hook up alt and fill the rad.
May have found why I've had a problem getting the gaskets to seal. There is a metal tray that sits over the lifter valley. Three tabs on each side clip over bottom edge of head and stick up enough that 2 of the 3 are sandwiched between head and intake. Maybe keeping the intake from pulling down tight against gaskets. Trimmed them off so we'll see.
__________________
Hank
70 Chevelle SS396(454), M20, 3.73
My Chevelle
|