View Single Post
  #14  
Old 03-10-2016, 06:12 PM
Hank70SS's Avatar
Hank70SS Hank70SS is offline
Moderator
 
Join Date: Dec 2009
Location: Brighton, MI
Posts: 4,719
Default

This is, obviously where the vanity goes. We found a vanity and counter top Lynda wants. Old vanity was 48" with center doors and drawers on each side. New vanity is basically a 30" cabinet with 2 doors on the left and an 18" cabinet with 4 drawers on the right. A quartz counter top with sink offset to left over the 30: cabinet. Sounds great, except. Except drain pipe comes up right where the 2 cabinets join and cold water inside the 18" cabinet. That won't work so I have to cut out sub-floor and move the plumbing to the left under the new sink.



I may have to cut out the sub-floor and replace the toilet flange too. It sits 1.5" above the sub-floor. The new cement board and tile will be around 3/4" so the flange may sit too high. I'll have to drag out the toilet and measure the bottom drain flange and see.



Removed trim around the window so I could measure the rough opening. Only window in the house that I haven't replaced. Figured I better do it now. That's it for now
__________________
Hank

70 Chevelle SS396(454), M20, 3.73
My Chevelle
Reply With Quote