|
|
|
#1
06-22-2011, 09:23 PM
|
|||
|
|||
Ok i have a lot of questions with pics :)
ok guys and gals incase you didn't know i am learning about my motor so i took some pictures and questions that i am not sure of.
ok so what is this nut looking thing on the upper control arm  looking at this trans arm does this look right?  ok not sure but i know one is for the throttle cable and one is for the speedo cable right?  wiper motor?  not sure on this one but why is this closed up?  same thing what goes here? 
__________________
2005 dodge magnum daily driver 1988 mazda rx7 LS6 swap 1969 SS work in progress 
|
|
#3
06-22-2011, 09:33 PM
|
|||
|
|||
|
what goes here? i know it runs to the water pump right?
 what bolts here right under the intake bolt and over it  what about the two holes next to the water neck 
__________________
2005 dodge magnum daily driver 1988 mazda rx7 LS6 swap 1969 SS work in progress
|
|
#4
06-22-2011, 11:18 PM
|
||||
|
||||
|
I'll help with what I can...
Pic #1: I'm guessing that nut had some sort of a screw-in bumpstop as a travel-limiter. Not stock Pic #3: top hole is throttle cable, lower hole (and adjacent round hole) were plugged on my car from the factory. Speedo cable comes through lower than those holes. Pic #4: Yes, wiper motor goes there. There is a stamped bracket missing too Pic #5: The upper plate shouldn't have a hole there... not sure why that's there. The lower (big) plate is covering the holes for the heater & A/C. Pic #6: Should not be a hole there. Pic #9: Square hole is where the fuse block goes
__________________
Derek Kiefer, member of Minnesota's Northstar Chevelle Club 69 Malibu Pro-Touring - 69 SS396 3spd - 23 Model T roadster pickup
|
|
#6
06-23-2011, 08:42 PM
|
||||
|
||||
|
Derek is the man !
__________________
Get in, sit down, shut up, hold on...cause Ms Grumpy is driving ! For the audio geek try: www.audiokarma.org
|
|
#8
07-02-2011, 06:36 AM
|
||||
|
||||
|
Second set of pictures.
#1, a hose nipple screws in, should look like the one in the back of the water pump. Small piece of hose connect the two. #2, the 2 standoffs with tapped holes are for mounting a stock type ignition coil. #3, hole on the right gets another hose nipple screwed in, heater hose goes to it. Other hole is extra, can be used to mount a temp sensor or plugged. Last pic, is that the rear base of the carb? Vacuum hose to power brake booster.
|
|
#9
07-02-2011, 07:39 PM
|
||||
|
||||
|
OK..Hank is the man too..
__________________
Get in, sit down, shut up, hold on...cause Ms Grumpy is driving ! For the audio geek try: www.audiokarma.org
|
|
#10
07-04-2011, 12:15 AM
|
||||
|
||||
|
Quote:
__________________
Derek Kiefer, member of Minnesota's Northstar Chevelle Club 69 Malibu Pro-Touring - 69 SS396 3spd - 23 Model T roadster pickup
|
 |
|
|
Linear Mode
