![]() |
|
|
|
#1
|
||||
|
||||
|
Boy you guys are busy. The only thing that I did today was talk about my car.
__________________
Get in, sit down, shut up, hold on...cause Ms Grumpy is driving ! For the audio geek try: www.audiokarma.org |
|
#2
|
|||
|
|||
|
I went out to the shop and got the GPS out ,does that count ? All my time lately has been spent at the rental house trying to repair everything the previous tennants destroyed and spending quality time with our newly unofficially adopted boys.The boys are very fun and rewarding so I look forward to that ,the house not so much.
__________________
John |
|
#3
|
|||
|
|||
|
installed my new sending unit and gasket tomorrow i will install the gas tank and see if i can run a new line from the rear to the front
__________________
2005 dodge magnum daily driver 1988 mazda rx7 LS6 swap 1969 SS work in progress |
|
#4
|
|||
|
|||
|
I looked at the Chevelle and El Camino for about 2 seconds then went to the renter house.
__________________
John |
|
#5
|
||||
|
||||
|
I hobbled past it and looked at the body work I did a week ago. I have an engine to build, then I can get back to it.
__________________
Alan 1964 Chevelle SS Speed's expensive, how fast do you want to go? |
|
#6
|
|||
|
|||
|
Drove the '67 again today...lovin' this Fall weather!!
![]() Engine's running sweet...too bad it's coming out next month.
__________________
2017 Camaro RS -217 cu in 365 HP w/8 speed auto 1967 Camaro SS -5.3L LS w/4L60E & 4.11 12 bolt 2019 Cadillac XT5 3.6L V6 w/310 HP & 8 speed AWD |
|
#7
|
|||
|
|||
|
What you doing this time Bill ?
__________________
John |
|
#8
|
|||
|
|||
|
Not a thing....
|
|
#9
|
|||
|
|||
|
Thing was a car? by Volkswagon way back when.
__________________
John |
|
#10
|
||||
|
||||
|
I think John is confusing threads again by starting with the last word.
I stopped by the speed shop to check on the progress of the 70. Should be finished up this week in time for a couple of cruises planned for this next weekend! Bill, If you are swapping motors, what are you doing with the old one (its a 468 right?) Or are you just pulling it to do more to it?
__________________
Eric 496 cu. in. "cruiser" Assembled & tuned by Mo's Speed Shop - Dallas, GA Last edited by fleming23; 10-24-2011 at 07:44 AM. |
![]() |
| Thread Tools | |
| Display Modes | |
|
|