![]() |
|
|
|
#1
|
|||
|
|||
|
i need to clean around my chevelle just so i can get to it..lol
__________________
2005 dodge magnum daily driver 1988 mazda rx7 LS6 swap 1969 SS work in progress |
|
#2
|
||||
|
||||
|
I'm bummed, Motor got delayed a week. Ready to move car today and was told to hold for a week.
__________________
Ray 1970 SS Chevelle Van Nuys Built Last edited by shadowgray396; 05-30-2012 at 11:43 PM. |
|
#3
|
|||
|
|||
|
Ray ,that stinks.
__________________
John |
|
#4
|
|||
|
|||
|
Stinks and wife are two words that should never be used in the same setence.Especially when speaking to the affore mentioned wife. Is this on topic?
|
|
#5
|
||||
|
||||
|
Just like your truck Flash, you expect things to get done and other people don't seem to have the same priorities. Been told he would be ready and took in a couple more cars to fix ahead of me. It's a friends shop but was going to be able to use it for the weekend to get my motor in. Looks like next weekend now.
__________________
Ray 1970 SS Chevelle Van Nuys Built |
|
#6
|
|||
|
|||
|
I didnt even have time to visit my shop today to see the chevelle and Elky much less do anything .
__________________
John |
|
#7
|
||||
|
||||
|
Took over some brackets for the motor today, was going to work on it for a while, but my friend had family over so did get a chance to put them back on. Picked up a neww throttle cable, new heater switch, under the dash light wiring harness and a few odds and ends I needed.
__________________
Ray 1970 SS Chevelle Van Nuys Built |
|
#8
|
|||
|
|||
|
Finally have a day off, and pretty much told everyone to leave me alone. I haven't had any time for my car, VERY irritating. I managed to press the new bushings into the lower control arms, then paint them. We'll see what I am able to get done after lunch.
![]()
__________________
1972 SS 454 Chevelle LS5/M21/12 bolt 3.73 posi 1969 Malibu COPO L72/M20/12 bolt 3.31 posi 1968 Malibu LQ9/4L80E/12 bolt 3.73 posi |
|
#9
|
|||
|
|||
|
That looks good ,I have yet to do anything with our chevelle today but will get her packed and ready for Chevellabration in a little while.
__________________
John |
|
#10
|
|||
|
|||
|
The finished product... I unmasked them and installed the new bump stops.
![]() I started to apply paint stripper to the last upper control arm, and it started to rain. So, my day was ended early due to weather. I work a long day tomorrow, so I highly doubt anything more will get done.
__________________
1972 SS 454 Chevelle LS5/M21/12 bolt 3.73 posi 1969 Malibu COPO L72/M20/12 bolt 3.31 posi 1968 Malibu LQ9/4L80E/12 bolt 3.73 posi |
![]() |
| Thread Tools | |
| Display Modes | |
|
|