|
|
|
|
|
#2
06-10-2012, 07:26 PM
|
||||
|
||||
This is the best picture I have taken in the last 6 months.
 Car is on the move  Car is at a friends shop, Motor is on the right side of the car. 
__________________
Ray 1970 SS Chevelle Van Nuys Built Last edited by shadowgray396; 06-10-2012 at 07:28 PM. 
|
|
#3
06-10-2012, 08:15 PM
|
|||
|
|||
|
Shouldnt tbe motor be in the front middle?
|
|
#4
06-10-2012, 10:47 PM
|
||||
|
||||
|
Quote:
__________________
Ray 1970 SS Chevelle Van Nuys Built
|
|
#6
06-11-2012, 09:04 AM
|
||||
|
||||
|
I wanted to pick my car up yesterday. But after a full day at Chevellabration, then the 9+ hour drive home. I took David out to b'fast and ended up being awake for 30+ hours and finally crashed at about noon on Sunday. Hopefully I will be able to pick it up tonight, as long as it doesn't rain.
__________________
Get in, sit down, shut up, hold on...cause Ms Grumpy is driving ! For the audio geek try: www.audiokarma.org
|
|
#7
06-11-2012, 02:36 PM
|
||||
|
||||
|
Ordered a hydro-boost conversion from Hydratech. Should be here in 3 weeks or so.
After a few hundred miles this weekend I realized the big block just isn't making enough vacuum (8-10") to support the 11" booster & Wilwood calipers. It was a little concerning at the end of Music City's 1/8th mile when trying to slow the car down but I managed, just didn't feel comfortable doing so. This should cure my stopping concerns!
__________________
Eric 496 cu. in. "cruiser" Assembled & tuned by Mo's Speed Shop - Dallas, GA
|
|
#8
06-11-2012, 09:28 PM
|
||||
|
||||
|
Quote:
__________________
Get in, sit down, shut up, hold on...cause Ms Grumpy is driving ! For the audio geek try: www.audiokarma.org
|
|
#9
06-11-2012, 04:56 PM
|
|||
|
|||
|
Took frame and lower control arm to powder coat shop and ordered lower control arm ball joints and bushing.
|
|
#10
06-11-2012, 05:38 PM
|
||||
|
||||
|
Can't believe my luck
Right now I'm so mad I could ******. Just found out the wire harness for the engine is the wrong one and since I purchased it over a year ago I now have to buy another one for the car meaning more delays, maybe up to 3 weeks. Turns out the one I have is for a full size car and not for my Chevelle, plus it doesn't have the HEI wire I need in it. Nothing on this build has gone right it seems. Just about ready to sell it and be done with it. Can't believe my luck with this project.
__________________
Ray 1970 SS Chevelle Van Nuys Built
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
