What Did You Do To Your Chevelle Today

[RBeckman]

Originally Posted by chevymaher

Mine was where the sender strap grounded to the metal. It got loose on the rivet.

I went out and looked at that and it is bolt and not riveted on mine and will clean that to see if that works. Also noticed a gas leak at the rubber line where it meets the metal line so that has to be fixed as well.

[carpoor]

Originally Posted by RBeckman

I got it started and noticed that the gas gage is not working....it worked when I put it away. Any suggestions

Most likely the same reason the clock doesn't work.

[RBeckman]

Originally Posted by carpoor

Most likely the same reason the clock doesn't work.

Ha, Clock that does not work is in the Camaro and I think Tony did it to see how far he could push me.

[carpoor]

Ray, I found this image online of a 72' W-code car without AC. The orange wire looks like the one in my engine bay - it appears to run to the heater box. (for the fan motor, I think?) Anyhow, I don't believe I need it, my car has AC. Not sure why they put that in my harness? It's an American Autowire harness IIRC. Now I am just down to the one black wire I can't figure out.

[flash]

I didnt get my truck back today so we took the Malibu convertible out cruisin .

[flash]

Im too busy playing with the truck right now so the Chevelle has to wait .

[Ken Hayes]

And that's a good thing !!!!

[SS Shaun]

FINALLY!! after almost 2 months FINALLY!


now the fun starts tomorrow

[carpoor]

It runs! Have a fuel leak on both ends of the carb to pump line. (despite being tight) The tach wasn't working, just resolved that. And the key switch has issues... I will have to swap in the switch from the non tilt column out of the car.

Just the same... HUGE relief!

[shadowgray396]

Congrat, always go to hear them run.